Dez 2, 2014 - 3D-Druck News, 3D-Drucker

The WASP Resurrection System Provides an Open Source Stop and Save System for 3D Printers

Living in Florida, we experience thunderstorms on a daily basis in the summertime. Literally our power goes out for a few seconds at a time and this happens at least a few times a week. This makes running a 3D printer during the months of May, June, July, August and September almost impossible, unless you have it hooked up to a battery backup. Even then, there are times when the power is out longer than that battery can handle. Up until now, there really has not been a reliable method to recover a print job if the power running that 3D printer were to go out.
(…weiter auf 3dprint.com)




Tags: , , , , , ,

Comments are closed.